Week 4

Week 4 Notes:

  • Put the entire 3D model together.
  • Tested out the dispensing mechanism with different emotions and added a button to start the emotion detection.
  • Tested out the combination between the first phase and the second phase of the project working together.

 Challenges faced in Week 4:

  • We had issues putting the colour sensing and sorting mechanism into the 3D model, we had to recalibrate the movement of the servo that moves the skittle correctly.
  • We also had trouble aligning the funnel for the skittle sorter and had to find the new dimensions for the location of the funnel to make the top of the CANDI machine.
  • Placing the components into the machine took more time than we thought. Due to the number of wires required by the machine, we had to double-check that everything was connected in the correct place. 





Conclusion of the Project

  • The machine was successfully able to sort skittles by their colour and dispense them according to different human emotions.
  • We could have worked more on the "aesthetics" of the machine by making it look more like a candy machine.
  • The wiring in the back was well-organised with tape which corresponds to each mechanism.
  • Further testing would have been better to fine tune the machine a bit more to improve efficiency and speed.

Comments

Post a Comment

Popular posts from this blog

Week 1

Image
Background and inspiration  Our project  CANDI (Candy Allocation & Notation Dispensing interface),  aims to sort skittles into containers by using a colour sensor that detects RGB values of the candy and then  dispenses coloured candy based on the facial expression of the person in front of the camera. The  camera detects the facial expression of the person in front of the machine and dispenses coloured candy based on the emotion, i.e., angry = red. We first decided to integrate the Raspberry pi and the Arduino to work coherently, but after some time its been decided that it would be better if each board is independent. The Raspberry pi would be in charge of the emotion detection and move the motor based on the emotion that is most dominant, whereas the Arduino is responsible for the sorting of the skittles. Week 1 objectives: Finalize the 3D design model. Write code for Candy sorting. Write code for Emotion detection. Write code for Dispensing. Test the ind...
Read more

Week 2

Image
Week 2 Notes: Considering the issues with the colour detector faced in week 1, we found a new way to calibrate and find the correct colours for each skittle, by taking multiple samples of RGB colours of each skittle. However, the detection would work better if it was in a fixed position instead of being handheld.  The SD card for the raspberry pi was flashed and setup so that the code for the face recognition could be tested and implemented using the raspberry pi camera module. Started 3D printing individual components of the machine. Week 2 Objectives:  Test out the colour sensor in different environments to calibrate and find the most accurate thresholds to ensure accuracy in the sorting.  Run the facial recognition tests to determine the efficiency of the raspberry pi camera module and if it detects the emotions correctly. Attempt to print out the 3D components. Challenges faced in week 2: The LED keeps flickering whenever the servos move due to the voltage drop, which...
Read more